Failure

Describtion

Solution

Manual start failure

Press the ENT key，the green light isn’t bright on the aboved and the motor doesn’t work.

Check whether the greenlight is broken,if the LED light isn’t broken,please contact with the factory;If the LED light is broken,please see below solution.

Press the ENT key，the green light is bright on the aboved and the motor doesn’t work.

Check the menu of“low oil pressure”in the “input port state”,if display “0”,please check whether the oil pressure sensor is ok;if display “1”,the oil pressure sensor is ok,now please press START,measuring the module port 34 “start” whether there’s 24V with a multimeter,if the voltage is 24V,check whether the outside middle relay,start moter is broken,and whether the battery voltage is enough;If port 34 no output,the module might be damaged.

Auto start failure

Module in Auto state,inspection “remote start” have input, the “remote start” state light isn’t bright and the motor doesn’t work.

Check the? menu of “remote start” in the“input state”,if the “remote start” display “0” means that the outside timer etc module relay is broken cause didn’t receive the input signal;If display “1”,the module might be broken.

Module in Auto state,inspection “remote start” have input, ?the “remote start” state light is bright on and the motor doesn’t work.

Check the oil pressure sensor; Switch to the manual start, check whether there’re output signal of the port 34- “remote start”, the outside components and the battery voltage.

Wheel tooth is fighting when start

Start successful and motor keep running, the whell tooth is fighting.

Lower down the trip speed;

Suggest used speed sensor to get the rotate speed.

On load current display incorrect.

Current ratio setting incorrected.

Reset the current ratio.